This opens the Punching Machine Setup /*window. How do I generate G98 in auto sequence?Ĭlick 'Machine' pull down menu and go to 'Info'. By modifying these two values, the job can be done however, any incorrect result will be programmer뭩 responsibility.Ħ. AP100US will take the pitch factor times the material thickness and will not assign any tool smaller than that value. The default value is 1.5 which means AP100US will not auto-assign tools that are smaller than 1.5 times the material thickness. AP100US uses Pitch Factor when it assigns auto tooling.
Also it can be imported to Enhanced Importer, saved it as *.prt file then bring it back to AP100US.ĪP100US will not do auto tooling on small sized round holes.This is one of the safety features in AP100US program. In this case, either the part has to be re-programmed in AutoCad or simply re-drawn in AP100US. This happens when there are multiple layers on the part created in previous program such as AutoCad. AP100US creates multiple tool hits on a single entity of the part when it brought in *.dxf format. I Change the file type to 멝achines ?then double click the machine file to overwrite.ĥ. How do I correct the error Opening file: 밆river Name"!" that occurs when AP100US starts?ī Click 멑ile?pull down menu then go to 멟pen?Ĭ Change the file type to 멝achines ?then double click to open the machine file.ĭ Create or load the material file associate with the machine file.Į Click 멝achine?pull down menu then go to 멗nfo?į Click 멣et driver?then double click to open the proper machine driver. How do I correct the error 밫ools not found in inventory" that occurs when AP100US starts?ī In AP100US click 멟ption?pull down menu and go to 멠references?Ĭ Make sure that the right tool inventory file has been set as 멠unching and Cutting Default Files?ĭ Open the tool inventory file by going 멝odules?pull down menu.Į Check and see if all the tools have been added.į Locate the tools from the error message and check all the information including angles.Ĥ. Highlight ?stp?file then click File-Print.ģ. In the 멹iles of type? click on all files. Locate C drive, AP100US, Fabriwin, FC2001. Set the value of 몊etup sheet ?to 0.Ĭlick 멑ile?pull down menu and make sure 멟utput Machine Set?has checked.
#Amada ap100 software installation problems install#
A Open Windows Explorer and locate AP100US folder under the root (C:\) directory.ī Rename it to something different, for example 멇P100USOLD?Ĭ Click Start-Run on Windows Start menu then type 몊ysedit?and hit Enter.ĭ Pick the WIN.INI screen and look for ?FabriCAM]?line then rename it, for example ?FabriCAMold]?Į Now, insert AP100US program CD and install product then reboot the computer.į Open Windows Explorer and copy over old files including part, sheet, driver, machine file to the new AP100US directory.Ĭlick 멝achine?pull down menu and go to 멐dit Material?